Hatco Strip Heater GRS-30-I

Changing the Setpoint Temperature

Press the key three times to display the current setpoint temperature.

Press the key or key within 10 seconds to change the setpoint temperature.

Press the key to lock in the new setpoint temperature.

Changing Fahrenheit and Celsius Setting

Press the key once to display current temperature unit.

Press the key or key within 10 seconds to change between Fahrenheit and Celsius.

Press the key three times to lock in the new temperature unit setting.

Turn off the unit and unplug the power cord

Remove and wash all food pans, if necessary

Wipe down all metal surfaces with a non-abrasive, damp cloth

Describe any stubborn stains and cleaning methods used

Clean hard to reach areas using a small brush and mild soap

Wipe dry all surfaces using a non-abrasive, dry cloth

Turn off the unit and unplug the power cord

Installation of Adjustable Legs

Carefully turn the unit upside down and lay it on a flat surface

Cover the surface to prevent scratching the unit

Thread a 102 mm (4′′) leg into the bottom of the unit at each corner

Hand-tighten each leg until snug without over-tightening

Read all safety messages in the IMPORTANT SAFETY INFORMATION section before operating this equipment.

Plug unit into a properly grounded electrical receptacle of the correct voltage, size, and plug configuration.

Move the Power On/Off (I/O) switch to the On (I) position.

Turn the thermostat control to the desired temperature setting.

Allow the unit 30 minutes to reach operating temperature.

Adjust the temperature control clockwise to increase the setpoint temperature

Adjust the temperature control counterclockwise to decrease the setpoint temperature