Euroklimat Water-Cooled Chiller IPE 51

Ensure the power on/off switch is set to off (position ‘0’) and padlocked.

Verify there are no moving parts.

Observe accident-prevention regulations in force.

Put on adequate personal protective equipment

Visual Inspection and General Cleaning

Conduct a thorough visual inspection of the equipment.

Perform general cleaning of the equipment.

Ensure the power on/off switch is set to off (position ‘0’) and padlocked.

Verify there are no moving parts.

Observe accident-prevention regulations in force.

Put on adequate personal protective equipment

Open the upper front panel once the unit has stopped.

Press on the drive belt with fingers at the indicated points.

Visually check for dirt on the coil (e.g., paper, dry leaves, dust).

Ensure the power on/off switch is set to off (position ‘0’) and padlocked

Verify there are no moving parts

Observe accident-prevention regulations

Wear adequate personal protective equipment

Visual Inspection and Initial Setup

Conduct a thorough visual inspection of the equipment

Open the upper front panel once the unit has stopped

Press on the drive belt with fingers at indicated points

Ensure the power on/off switch is set to off and padlocked in that position.

Verify that there are no moving parts.

Observe the accident-prevention regulations in force.

Put on adequate personal protective equipment

Ensure all operations except visual inspections are carried out by specialised personnel.

Contact Euroklimat for operations not contemplated in this manual.

Perform a thorough visual inspection of the equipment.