Chicago Pneumatic Air Compressor CPVS 25

Renovation of the housing. Use the suction housing kit.

Check the cleanliness of the oil return pipe and the state of the seal

• Dismantle the complete oil return check valve.

• Lift the oil stop valve pipe.

Air / Oil cooler and Final coolant

Blowing of cooling elements and Cleaning

The aluminium oil and air cooler is a vital part in the CP Compressors system. Please take care of this element. To prevent the nest of tubes from being deformed or damaged, when assembling or disassembling the cooler unions and hoses, the cooler sleeves' must be kept rotating by means of a wrench.

The outer surface of the nest of tubes must always be kept clean in order to enable proper heat transfer. In the event of a leak, the source of the leak must be detected. In order to do this:

- Look for leaks using conventional means (soap solution, ...).

Draining cock: G - Draining condensation water

Draining of condensates in the oil circuit

Condensates in the oil circuit drained?

Enter the number of hours since the CP Compressors has been shut down

Oil change tap opened slowly and water escaped?

Valve closed immediately when oil appeared to avoid any loss?

Oil level: Check and top up if necessary

The air filter is a dry, encapsulated type. In standard conditions of use, change the cartridge every 2 000hrs. This can be done through an easy access from the front panel. Check the cleanliness of the filter every week and change it if necessary.

If you do not replace the filtering element when needed, permanent dirt build-up will result. This reduces the air inflow to the compressor and could damage the oil separator and the compressor.

Warning: This maintenance check requires trained personnel with PPE!

Control cleaning lubrication check

Renovation of the housing using the suction housing kit

Sign off on the air compressor maintenance