Bosch Hammer SDS Plus Rh328Vc

Warning! To avoid accidents always disconnect the tool from the power supply before cleaning or performing any maintenance

Tool disconnected from power supply

The tool may be cleaned most effectively with compressed dry air. Always wear safety goggles when cleaning tools with compressed air

Tool cleaned with compressed dry air

Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through openings

Ventilation openings and switch levers clean and free of foreign matter

CAUTION! Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia

Check if any of these cleaning agents were used

Warning: Only use genuine Bosch replacement brushes for your tool

Tool shut off indicating need for brush replacement?

Upload a photo of the current state of the brushes

Select the type of Bosch replacement brush used

Enter the tool's hour meter reading

Sign off on the brush maintenance

Tool has been properly lubricated and is ready to use

Tools with gears have been regreased with a special gear lubricant at every brush change

Every second brush change, the bearings have been replaced at Bosch Factory Service Center or Authorized Bosch Service Station

Bearings which become noisy (due to heavy load or very abrasive material cutting) have been replaced to avoid overheating or motor failure

Sign off on the hammer maintenance