BOFA International Fume Extraction Unit V250

Cleaning the Powder Coat Finish

Clean the powder coat finish with a damp cloth and non-aggressive detergent

Cooling Inlets and Outlets Maintenance

Clean the cooling inlets and outlets to prevent dust build-up and overheating

Fire Risk Assessment and Precautions

Conduct a risk assessment to determine if additional fire protection equipment is needed

Evaluate maintenance procedures to prevent debris build-up that could combust

Usage Restrictions and Precautions

Ensure the unit is not used on processes where sparks could occur, with explosive dusts and gases, or with pyrophoric particulates without additional precautions

Verify that all safety equipment is available

Check that all components are in place

Is the airflow rate within the acceptable range?

Inspect the condition of the filters

Inspect the condition of the ductwork

Isolate the electrical supply to the extractor

Undo the clips on the sides of the unit and remove the lid

Lift the filter out of the unit and bag and seal the used filters

Lower the new filter into position

Replace the lid and fasten the clips

Isolate the electrical supply to the extractor

Undo the clips on the sides of the unit and remove the lid