Fan Inspection
This checklist guides personnel through the inspection of the fan and its associated components. Complete the applicable checks according to manufacturer instructions, record findings, and report any defects requiring corrective action.
Fan Inspection
The aim of this checklist is to assess the fan’s condition and operation through routine checks for wear, damage, loose components, unusual noise, and vibration. It helps identify issues early, supports consistent airflow and reliable performance, and reduces the risk of unexpected breakdowns.
Fan Wheel Inspection
(Pictures Require) Open the hatch or access door to inspect the fan wheel. take pictures of the wear on the fan blades or any damage. Measure the thinnest worn point of the fan blade.
Fan liner inspection
(Pictures Required) Please look at all viewable sections of the liner for any spots that are thin or worn through. Look at the outside of the housing relative to any questionable areas on the inside to know if those need to be patched. If a spot needs to be patched, please do so at the time of inspection or make a metal patch and have it welded possible.
Ductwork Inspection
(Pictures Required) Check the ductwork before the inlet and after the outlet of the fan for any signs of material blowing out. be sure to check around the flanges, welds, bends etc. for any signs of cracking or leaks. Please note the location of any leaks relative to the fan. Example: the 45 before the inlet. If you do find any leaks, please have them welded if possible or patched with belting and duct tape until it can be patched properly.
Vibration check
Listen and feel for any excessive vibration on the motor, fan housing, bearing, guards and belt guards. Please list any findings whether they are good, bad or questionable.
Cleanliness check
Observe the current condition of the fan as seen and look for any excess blow out from the fan housing. Check to see if the guards covering the bearing are packed with material that might cause a premature bearing failure. Note where the material is coming from, if you can find the source. Blow out the guards, housing etc. once you have identified any leaks. IF the fan is off during your inspection, please remove the guards for cleaning
Bearing Inspection
Inspect bearing hardware to ensure that everything is tight. Validate that any external grease lines function properly and grease is making it to the bearing. Wipe away any excess grease from the bearings. Check that the locking collars for the bearings have the tab bent in on one of the tabs. Check the set screws on the collars to verify they are tight.
Belt and Sheave Inspection
Source: CleanFiber (Community Member)
