SPIRAL COOLER BELT CLEANING

BELT CLEANING

• TURN ON THE WATER TO THE PRESSURE WASHER. ( MAKE SURE THAT THE WATER DOES NOT GO INTO THE TANK UNTIL THE PRESSURE WASHER IS TURNNED ON.)

• TURN ON THE PORTABLE WASHER. (WATCH THE FLOAT SWITCH IN THE TANK AND MAKE SURE THAT IT IS WORKING. THE WATER SHOULD STOP AT ABOUT 2-4 INCHES FROM THE TOP OF THE TANK)

• . OPEN THE BOTH WATER VALVES AT THE PRESSURE WASHER

• MAKE SURE THAT THE UPPER AND LOWER WASHING SPINDLES ARE TURNING AT THE SPIRAL WASHING UNIT. (THEY SHOULD BE SPINNING FAIRLY FAST.)

• . WITH A CISSOR LIFT PLACE DAWN DISH SOAP SOAKED BLUE PAPER TOWEL ON EACH TRACK (OUTER, MIDDLE, AND INNER).

• . REPEAT ITEM 5 EVERY 4 LAYERS UNTIL YOU REACH THE BOTTOM OF THE SPIRAL

• CHANGE THE SPIRAL SPEED TO 90 MIN. AND RUN IT FOR 4 ROTATIONS THEN STOP IT

• REMOVE ALL OF THE BLUE TOWELS.

• TIE A BLUE TOWEL TO THE OUTER EDGE OF THE BELT AT THE BOTTOM OF THE CONVEYOR.

• CHANGE THE SPIRAL SPEED TO 60 MINUTES

• TURN THE PRESSURE WASHER ON FIRST THEN THE SPIRAL LET IT RUN FOR ONE COMPLETE ROTATION OF THE BELT. (THE BLUE TOWEL ATTACHED TO THE OUTSIDE WILL LET YOU KNOW WHEN THAT IS DONE.)

• TURN OFF THE SPIRAL. LET THE PRESSURE WASHER RUN FOR 2 MORE MINUTS AND THEN TURN IT OFF.

• WITH A SCISSOR LIFT AT THE TOP OF THE SPIRAL PLACE LUBRICATION RAGS ON EACH TRACK (OUTER, MIDDLE, AND INNER).

• TURN THE SPIRAL BACK ON UNTIL THE RAGS REACH THE BOTTOM.

• REMOVE ALL RAGS, TOOLS, EQUIPMENT. CLEAN AREA. RUN SPIRAL FOR PROPER OPERATION.