NXG MCS Settings Editor Validation
This Procedure validates NXG MCS settings against the ECP by checking scan card, filter, drives, lid applicator, cooldown, scanner alignment, layer control, build, and DPC parameters, then uploading verification screenshots.
Divergent 3D
09/11/2025
NXG MCS Settings Editor Validation
This Procedure validates NXG MCS settings against the ECP by checking scan card, filter, drives, lid applicator, cooldown, scanner alignment, layer control, build, and DPC parameters, then uploading verification screenshots.
Scan Card Settings
Value : 0
Permeant Filter Settings
Value : 80%
Value : 35mbar
10g
Value : 2%
Value : 5s
Value : 240 min
Value : 10Kg
Value : 2Kg
Value : 12h
Drives Settings
Value : 290 mm/s
Value : 180 */s
Lid Applicator Settings
Value : Checked
Value : 2
Cool Down Settings
Value : 0
Value : 200*c
Value : Disabled
Value : 5mm
Scanner Align Settings
Value : 20 seconds
Value : 150
Value : 200
Value : 50,0000us
Value : 0.13mm
Value : D:\Logs\ScannerAlign
Value : 5 min
Value : On
Value : 0.02mm
Value : 200 us
Value : Disabled
Value : 0.1mm
Value : Enabled
Value : Layer 10
Value : After Recoating
Value : Layer 60
Layer Control Camera Settings Cam 1
Value : 40,000us
Value : Enabled
Value : Enabled
Value : Enabled
Layer Control Settings
Value : Disabled
Value : Enabled
Value : Enabled
Value : Enabled
Value : 0.2
Build Settings
Value : 2
Value : 0ms
Value : 5
1
Value : 0.1%
DPC Settings
Value 1.7
Upload Screenshot of MCS Settings 1
Add or drag pictures
Upload Screenshot of MCS Settings 2
Add or drag pictures
Source: Divergent 3D (Community Member)