Auto 10 Electrical Inspection

Health and Safety

Needed tools: 1-Screwdriver Set 2-Ohm/Voltmeter 3-Lock and tag •Only licensed electricians must be allowed to perform electrical services. •Always turn off and lockout the main power to the machine before making any mechanical, hydraulic or electrical adjustments or performing maintenance. •High-voltage electricity located inside panels and throughout the machine can cause serious injury or death if contacted.

• 1) After lockout out the electrical power, open the table disconnect enclosure.

• 2) Check the main terminals with a voltmeter, to ensure no voltage exists.

• 3) High-voltage electricity located inside panels and throughout the machine can cause serious injury or death if contacted.

Supervisor Validation after LOTO

Technician validation after LOTO

Electrical Inspection

• 1) Open the main electrical enclosure under the dashboard.

• 2) Remove the plastic protective covers and check each screw on the electrical components and terminal strips to ensure that they are tight.

• Pay particular attention to the high-voltage terminal screws on the top and bottom of the magnetic starters and overload blocks. If any of these screws work loose, the connection will arc and overheat. This may burn the wire and terminals. Check the two screws holding each of the three overloads in place, to ensure they are tight: 3) Replace the plastic protective covers over the terminals of the electric components

• 4) Inspect the electrical conductor rails, rail clamps, and the collectors located under the table.

• 5) If any components or wires show evidence of overheating, they must be replaced.

Electrical Components Inspection

• Pass
• Flag
• Fail