For units equipped with an air filter. Each month check the air filter to be sure it is clean and allows proper airflow.
Air Filter Location
Cleaning the Condenser Coil
Caution: Never use a high-pressure water wash for this cleaning procedure as water can damage the electrical components located near or at the condenser coil.
Product Line Flush
NOTE: The following procedures are the basic product line flushing instructions. On-screen instructions can vary depending on the recipe that was created with the MenuConnect program or options chosen in the Managers Menu.
The Product Line Flush procedure allows a user to choose which lines to flush instead of being forced to flush every product line in the unit.
These items are optional and may not be displayed on all easyToUCH screens during the Product Line Flush procedure
NOTE: Performing the product line flush through this interface procedure will not reset the Zone 2 cleaning countdown timer, Zone 2 cleaning will need to be performed in its entirety in order to reset the counter.
GATHER THE FOLLOWING SUPPLIES
Follow the on screen instructions and gather the following supplies:
If other cleaners are used, it is possible they will not clean or sanitize your machine to NSF standards.
At Back Room Sink
Prepare Cleaning Solutions
Follow the on screen instructions and fill each labeled bucket to the fill line with the appropriate solution and bring to machine.
Spray and wipe refrigerator surfaces with new sanitized
Connect Cleaning Tubes
Select Slots to Flush
Select Slots to Prime
NOTE: If a line that does not have product assigned was cleaned, it will not need priming.
Auto Prime Complete
Importan: Do Not pour down the drain on the BIC unit!
Dispensing Area Cleaning
Important: Do Not Insert a brush or sharp object into the red dispense nozzles.
Dispensing Area Sanitizing
Product Line Flush Completed
Source: Manitowoc (www.partstown.com)