Back
Manufacturing / Industrial • Inspections

Conveyor PM - Roller

This procedure outlines the preventive maintenance steps for conveyor rollers to help ensure smooth, reliable operation. It focuses on inspecting rollers, drive components, belts, bearings, and guards to reduce wear and prevent unexpected downtime.
Mannington - Calhoun
03/23/2026

Conveyor PM - Roller

A scheduled preventive maintenance check of the Fife guide system to inspect and service all critical sensor, actuator, alignment, and control components, ensuring consistent web guiding accuracy and minimizing the risk of misalignment-related defects or unplanned downtime during production operations.

    Check each individual conveyor roller condition and bearings

    Inspect drive sprockets

    Check / Adjust chain tension

    Lubricate all bearings

    Inspect V-Belt or flat belt that drives conveyor rollers

    Check V-belt guide pulleys - Make sure grooves are clean, groove is not worn and Bearings

    Inspect V-Belt Jack shaft bearings, journal for wear and Lubricate bearings

    Blow out all yard material

    Make sure all gaurds are secure and proper

    Inspect and note any additional issues with unit

    Clean up area around conveyor and wipe down grease fittings

Source: Mannington - Calhoun (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.