RTFO Oven Verification Record
This procedure describes the Rolling Thin Film Oven (RTFO) Test, used to simulate the short-term aging of asphalt binders that occurs during the hot-mixing process
RTFO Oven Verification Record
This procedure describes the Rolling Thin Film Oven (RTFO) Test, used to simulate the short-term aging of asphalt binders that occurs during the hot-mixing process
Verified By
Date
Equipment/Model
Identification No.
Serial No.
Verification Equipment Used
Results
Thermometer
Serial number (Miller & Weber SN: 13C-86)
Distance from thermometer bulb to right side of the over (2 +/- 3/8 in)
Bulb level with carriage axis within 25 mm (1 in)
Apparatus
Rotation rate (15.0 +/2 0.2 RPM or 15 rev/60 +/- 0.8 sec)
Distance of air jet orifice to open end of sample container (6.4 +/- 0.8mm or 1/4 +/- 1/16in)
Flow meter standardized every 12 months (4000 +/- 100 mL/min)
Check horizontal axis of the bottles in the carriage level within +/- 1 degree)
Temp Controlling System
Temperature recovery time to 163 +/- 1 degree C within 10 minutes
Time to temp
Temp at 0.5 hr
Temp at 1.0 hr
Temp at 1.5 hr
RTFO Maintenance
Grease the chain
Remove air nozzle and clean
Air orifice (0.965-1.067 mm)
Replace carriage bushing
Check that nozzle and bottle gap is 1/4 inches
Check fan bearing
Ensure that carriage is level according to T240
Action Recommended
Comments
Source: Ergon - Lubbock 14842 (Community Member)