Emergency Maintenance (FRAMETEQ F-500 Nail guns)

Health and Safety

• Notify the affected Team Members of the Repair and maintenance work to be performed(Team lead and Operator)

• Identify the energy sources, potential health and safety hazards, all operational controls devices

• Place the CAUTION "MAINTENANCE IN PROGRESS" sign at the control station(s),and make sure it is secured and visible

• Press the Emergency stop button(Manually press the Emergency stop button)

• Locate the Light barrier safety device

• Wrap the device with 3' nylon sling and lock the sling with your logout-tagout lock.

• Validate the the light barrier turn RED

• Validate the light barrier error code is showing up on the Homag Software

• Test the error reset button ( error must remain)

• Test the Operating start button

• Wearing PPE is mandatory

• Control of the tools before usage

• Avoid pinch points (Can result to a severe injury)

• Never work between one or two movable mechanical devices (even with LOTO to adapt the philosophy)

• Never work under a weight (crush hazard)

• Conduct your repair and maintenance action safely

• Once finished inspect your area of work ( to be sure no tool was left or anything can provoke a safety hazard)

• Release the Emergency Stop button

• Open the padlock used for LOTO the light barrier and store the sling

• Take off the Maintenance in progress sign from the control station

• Communicate with the affected Team Members that the job was performed

Emergency maintenance

• Disconnect the two control air hoses

• Disconnect the nails sensors electrical plug

• With a 24mm wrench open the nut holding the gun on the plate

• Put a spare gun on the plate using 24mm wrench an tighten

• Put back the two control air hoses

• Connect the sensor electrical cable

• Bring the defective gun to the maintenance shop for a repair

• If the problem is with the manual valves do the necessary to fix in place with out taking out the gun

Inspection after work

• Pass
• Flag
• Fail

Technician Signature