PULVA PM
Bearings need maintenance to ensure they can continue to provide reliable service. While lubrication is critical for many bearings, hammer mill bearings have the potential to become over-lubricated. You should check your bearings once every six to 12 months to clean out old grease and prevent over-lubrication.
Gabbs - Premier Magnesia
02/13/2024
PULVA PM
Bearings need maintenance to ensure they can continue to provide reliable service. While lubrication is critical for many bearings, hammer mill bearings have the potential to become over-lubricated. You should check your bearings once every six to 12 months to clean out old grease and prevent over-lubrication.
Verify Pulva parts are in the warehouse
Proper PPE utilized
LOTOTO
Blow down assembly
Inspect Pulva reel
Inspect all wear liners
Inspect screens above Pulva
Inspect bearings on Pulva
Inspect Lovejoy coupler to motor
Inspect drive/non-drive bearings for leaks
Inspect seals
Inspect hammers for wear after removing housing cover
Inspect feed and discharge chute for wear
Ensure lid is installed and sealed
Torque all bolts
Inspect chain drive for wear and tension
Inspect Pulva bearings
Inspect base structure
Document any electrical wiring
Run assembly for proper operation
Source: Gabbs - Premier Magnesia (Community Member)