Back
General • Inspections

MDR Bracket Tightening – Spiral Conveyors

This procedure covers the inspection and tightening of MDR bracket hardware on the Spiral conveyors.
CSSI
02/03/2026

MDR Bracket Tightening – Spiral Conveyors

This procedure outlines the inspection and tightening of all MDR (Motor Roller) bracket hardware on the Spiral conveyors, ensuring the required tools are available, hardware is properly secured, and any issues encountered are documented.

    Tools Required

    Ensure you have the following tools

    Inspection and Tightening Procedure

    Tighten Hardware

    Was all hardware successfully tightened?

    • Yes
    • No
    • N / A

    Post-Inspection

    Describe any issues encountered during the inspection

    Provide details of any problems or obstacles faced while tightening the hardware.

    Inspector's Signature

    Sign to confirm that the inspection and tightening procedure has been completed.

    Click here to sign
Source: CSSI (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.