Back

L2Palletizer - Pull-Plate Coating

LINE 2 PALLITIZER STRIPPER PLATE COATING 1. Sand plate with random orbital sander and 120 grit sanding disk 15 minutes 2. Clean sanding dust with rag and denatured alcohol 5 minutes 3. Stir slip plate with stir stick to mix graphite into solvent thoroughly 10 minutes 4. Use 6” foam roller to roll on slip plate coating 30 minutes 5. Allow to dry 12 hours 6. Repeat steps 1 thru 5 for additional coats
KIK Products - Georgia
05/11/2023

L2Palletizer - Pull-Plate Coating

LINE 2 PALLITIZER STRIPPER PLATE COATING 1. Sand plate with random orbital sander and 120 grit sanding disk 15 minutes 2. Clean sanding dust with rag and denatured alcohol 5 minutes 3. Stir slip plate with stir stick to mix graphite into solvent thoroughly 10 minutes 4. Use 6” foam roller to roll on slip plate coating 30 minutes 5. Allow to dry 12 hours 6. Repeat steps 1 thru 5 for additional coats
Source: KIK Products - Georgia (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.