Ice Machine Pre Filter Replacement

Opening and closing a valve

Spanner Wrench Needed to Remove Pre-Filter Housing

Main water valve will be the first valve on the pipe coming out of the wall. Please see picture.

Most locations will have a blue valve with a hose attached directly under. Drain the water until no further water is in the clear drain hose. Please see picture.

Install new filter cartridge be turning the clear housing to the left. Please keep rag handy as water may splash out. Discard of the old pre filter. Install new cartridge* THERE IS A GASKET ( SEAL ) ON THE INSIDE OF THE CLEAR HOUSING. DO NOT MISPLACE ). Hand tighten the clear housing.

• Add scotch tape and write today's date, please stick on filter clear housing. Filters are to be replaced every 1 month from the date of replacement.

Draining new filters will clean and remove any loose particles inside the filter, thus keeping them from getting into the ice machine. Do this for about 2-3 minutes.

• 1: Open the main shut off valve about 1/2 way ( In the picture this is the yellow circled valve )

• 2: Open the blue water drain valve fully ( In the picture this is the blue circled valve )

• Close the valve directly behind the filters ( In the picture this is the pink circled valve ) This will keep water from flowing into the machine

Please follow steps in exact order.

• 1: Close the blue circled valve

• 2: Open the pink circled valve

• 3: Open the yellow circled