RETURN FEED IRONER LINE WEEKLY MAINTENANCE

13.1.1. Checking the HAND PROTECTION device Checking procedure: Switch off the power supply input switch breaker. Wait for at least five seconds and then turn the isolator switch on again. The ironer icon is displayed with the CHECK message, and the buzzer sounds. Press the hand protection device. The ironer icon disappears, the buzzer stops, and the MAIN MENU icons are displayed on the screen.
13.1.2. Checking the EMERGENCY STOP Checking procedure: Connect the ironer and start an ironing program. Press the emergency stop button. The roll will stop rotating and the heating system will turn off. The buzzer will sound and a warning message will be displayed stating that the Emergency Stop is activated. Unlock the Emergency Stop button. Press the STOP key on the multi-function keyboard. The Emergency Stop icon disappears, the buzzer stops, and the MAIN MENU icons are displayed on the screen................... The REV key allows the roll to rotate in the opposite direction to the linen input direction. Use only under exceptional conditions.

Turn off the isolator switch controlling the power supply to the machine.  Remove the screw (A) securing the filter to the back cover.  Pull on the filter handle.  Remove the lint and grime with a brush or by blowing with compressed air.  Refit the filter into the guide and push in right up to the stop.  Secure to the back cover with the screw.  Connect the power supply for the washing machine.

Clean the photocells and reflectors Clean off lint and dust residues with a dry cloth. If necessary, use a slightly damp cloth. Never use any abrasive element or anything that might damage the surface of the photocells or reflectors. Steps for cleaning the output reflectors and photocells (fig.13.2). The number of linen flow control devices will vary depending on the model of ironer.  Turn off the isolator switch controlling the power supply to the machine.  Turn the feeder tray upwards until it rests on the feeder straps.  Clean the roll linen output photocell signal reflectors A.  Clean the transmitters B signalling the output of linen from the roll.  Place the linen output tray in the work position.
Steps for cleaning the input photocells (fig.13.3). in Maint Manual The number of linen flow control devices will vary depending on the model of ironer.  Clean the linen input tray photocells.  Turn off the isolator switch controlling the power supply to the machine

Turn off the isolator switch controlling the power supply to the machine.
Disconnect the pipes A and B from the air pressure switch circuit (Fig.13.4).
Disconnect the pipes A, B and C from the air pressure switch circuit (Fig.13.4).

In accordance with safety directives, all electrical devices, mechanisms subjected to high temperatures (except in the collection of laundry), are to be protected by safety guards (covers) to prevent accidental contact with the same.
REMOVING ANY SAFETY GUARD FROM THE IRONER IS AN ACTION EXCLUSIVELY RESERVED FOR THE CUSTOMER’S TECHNICAL SERVICES (CTS) OR AUTHORISED TECHNICAL SERVICES (ATS).
THIS MUST NEVER BE ONE BY THE MACHINE OPERATOR. BEFORE PROCEEDING WITH THE REMOVAL OF ANY SAFETY GUARD THE PRECAUTIONS INDICATED AT THE BEGINNING OF THIS MANUAL AND IN THE PRESENT CHAPTER MUST BE OBSERVED. ONCE THE OPERATION THAT HAS LED TO THE REMOVAL OF THE PROTECTIVE COVERS HAS FINISHED, DO NOT RESTART THE MACHINE WITHOUT REFITTING AND SECURING ALL THE COVERS PROPERLY. NEVER START OR USE THE MACHINE IF ANY OF THE FOLLOWING ARE MISSING, INCORRECTLY POSITIONED OR MALFUNCTIONING:
COVERS ARE FITTED AND FUNCTIONAL AS DESIGNED
SAFETY DEVICES ARE FITTED AND FUNCTIONAL AS DESIGNED
CONTROL ELEMENTS ARE FITTED AND FUNCTIONAL AS DESIGNED

Click here to sign

Source: Aberdeen Laundry Service (Community Member)