Back
General • Inspections

BBR Verification Record

Procedure ACMP-OP-020: Use this procedure to make sure that you have the measurements for your BBR and for its maintenance.
Ergon - Lubbock 14842
05/23/2022

BBR Verification Record

Procedure ACMP-OP-020: Use this procedure to make sure that you have the measurements for your BBR and for its maintenance.

    Verified By

    Date

    Equipment/Model

    Identification No.

    Serial No.

    Verification equipment used

    Comments

    Calibrate according to manufactures instructions in software

    • Pass
    • Flag
    • Fail

    Check for sticktion test with two 2g +/- 0.2 weights

    • Pass
    • Flag
    • Fail

    S/N of weight

    Check center with center alignment beam

    • Pass
    • Flag
    • Fail

    Gage block

    Gage block #

    Top (15.996 +/- .005mm)

    Red (14.999 +/- .005mm)

    White (12.995 +/- .005mm)

    Blue (9.997 +/- .005mm)

    Thick Beam

    Thick Beam #

    Thickness (6.41 +/- .1mm)

    Width (12.7 +/- .25mm)

    Length (127 +/- .5mm)

    Thin Beam

    Thickness (1.3 +/- .3mm)

    Width (12.7 +/- .1mm)

    Length (127 +/- .5mm)

    Weights Verified

    ID #

    ID #

    ID #

    ID #

    Temperatures Verifed

    -12

    • Pass
    • Flag
    • Fail

    -18

    • Pass
    • Flag
    • Fail

    Maintenance as needed

    Action recommended

Source: Ergon - Lubbock 14842 (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.