Back

Total Productive Maintenance Checklist

A comprehensive Total Productive Maintenance (TPM) checklist covering autonomous maintenance, planned maintenance, quality maintenance, safety/health/environment, focused improvement, training, early equipment management, and documentation/compliance.
MX Traduction
11/17/2026

Total Productive Maintenance Checklist

A comprehensive Total Productive Maintenance (TPM) checklist covering autonomous maintenance, planned maintenance, quality maintenance, safety/health/environment, focused improvement, training, early equipment management, and documentation/compliance.

    Work Order Information

    Work Order Number

    Completed by

    Autonomous Maintenance

    Finding resolution status

    Planned Maintenance

    Inspect bearings for wear, noise, and temperature anomalies

    • Pass
    • Flag
    • Fail

    Check hydraulic and pneumatic system pressure levels

    • Pass
    • Flag
    • Fail

    Test sensor calibration and accuracy

    • Pass
    • Flag
    • Fail

    Inspect electrical connections for wear

    • Pass
    • Flag
    • Fail

    Check motor condition, including amperage draw and insulation resistance

    • Pass
    • Flag
    • Fail

    Inspect coolant systems for proper flow, concentration, and contamination

    • Pass
    • Flag
    • Fail

    Quality Maintenance

    Verify equipment output is within specified tolerance

    • Pass
    • Flag
    • Fail

    Inspect product samples for defects

    • Pass
    • Flag
    • Fail

    Check process parameters against baseline settings

    • Pass
    • Flag
    • Fail

    Test error-proofing devices and poka-yoke mechanisms

    • Pass
    • Flag
    • Fail

    Check material feed systems for consistency and alignment

    • Pass
    • Flag
    • Fail

    Safety, Health, and Environment

    Verify machine guards are in place, secure, and undamaged

    • Pass
    • Flag
    • Fail

    Confirm lockout/tagout devices are available and functioning properly

    • Pass
    • Flag
    • Fail

    Test emergency stop buttons

    • Pass
    • Flag
    • Fail

    Test safety interlocks and light curtains

    • Pass
    • Flag
    • Fail

    Inspect ventilation and exhaust systems for proper airflow and filtration

    • Pass
    • Flag
    • Fail

    Focused Improvement and Loss Tracking

    Check setup and changeover times against target benchmarks

    • Pass
    • Flag
    • Fail

    Training and Skills Development

    Early Equipment Management

    Verify equipment returns to baseline operating parameters after changeover

    • Pass
    • Flag
    • Fail

    Inspect recently installed equipment for proper alignment and leveling

    • Pass
    • Flag
    • Fail

    Documentation and Compliance

    Sign-off

    Additional notes / comments

    Completed Date

    Signature

    Click here to sign
Source: MX Traduction (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.