TX Area 3000 Daily Checklist
Use this daily checklist to verify equipment functionality, safety conditions, and operational readiness. Daily checks help maintain consistent performance, identify issues early, and support a safe and efficient work environment.
1005- TEXHOMA
04/09/2025
TX Area 3000 Daily Checklist
Use this daily checklist to verify equipment functionality, safety conditions, and operational readiness. Daily checks help maintain consistent performance, identify issues early, and support a safe and efficient work environment.
Check MCC to make sure Climate Control unit is working properly.
Check Instrument Air PSI @ PT-3823 if not at or < 80psi fail
Check H2S Analyzer at VAV's to make sure pump is running.
Inlet Coalescing Filters before Feed Compressors. (Replace filter is needle is in Red)
FC1
Check DP gauge @ V-2A (Replace if < 4.4)
Is Feed Compressor 1 Running? (If "NO" skip FC1 section)
Feed Compressor Oil Level @ V-2A
Check Coalescing Filter after Oil/Gas Separator. (< 6 Replace)
Record Condensate Pump Cycles
Check both Scavenger sight glasses.
Check DP across lube oil filters for LeRoi Compressor. (Replace if < 10psi)
Check DP @ both Coalescent filters. (Cooled Gas- replace if <6)
Listen for squeaking from both cooling fans.
FC2
Check DP gauge @ V-2A (Replace if < 4.4)
Is Feed Compressor 2 Running? (If "NO" skip next section)
Feed Compressor Oil Level @ V-2A
Check Coalescing Filter after Oil/Gas Separator. (< 6 Replace)
Record Condensate Pump Cycles
Check both Scavenger sight glasses.
Check DP across lube oil filters for LeRoi Compressor. (Replace if < 10psi)
Check DP @ both Coalescent filters. (Cooled Gas- replace if <6)
Listen for squeaking from both cooling fans.
Monitoring
GC Sample line pressure (Must be set to 15psi)
Check/Drain Coalescing Filter before Membrane by opening valve and checking DP gauge.
GC Cal Gas line pressure (Must be set to 15psi)
GC Cal Gas tank pressure (If less than 50psi replace)
GC Carrier gas line pressure (Must be set to 98psi)
GC Carrier gas bottle pressure (If less than 200psi replace)
Check GC for any active alarms. (Make note if any)
Check product gas temp @ PT-3717
Source: 1005- TEXHOMA (Community Member)