Bi-Annual Hoshizaki Icemaker Descale & Santize

Evaporator Condensate Drain Pan and Gear Motor Drain Pan

• Wipe down with a clean cloth and warm water

• Slowly pour one cup of sanitizing solution (Dilute 2.5 fl. oz. (74 ml or 5 tbs) of a 7.5% sodium hypochlorite solution (chlorine bleach) with 5 gal. (19 l) of warm water. This is a minimum amount. Make more solution if necessary.) into the evaporator condensate drain pan and then slowly pour one cup into the gear motor drain pan. Be careful not to overflow the pans.

• Repeat with a cup of clean water to rinse.

Extruding Head Seal Bolts

• Inspect for leakage around seal bolts. Tighten (see torque values below) or replace as necessary. Seal bolts must be replaced once removed because seal material is one-time use only. If new seal bolts do not have preapplied threadlocker, apply Loctite 243 or equivalent threadlocker to seal bolt threads. • Torque for F-1002 and Smaller: 11.1 ft-lb/15 N·m Tighten 2 times. Allow at least 5 sec. in between each tightening

Icemaker and Dispenser Unit/Ice Storage Bin Drains

• Check to make sure they are clear.