Back

2019 CLARK S25D IC Pneumatic 50-250 Hours PM

The 2019 CLARK S25D IC Pneumatic 50-250 Hours preventive maintenance form helps you check your truck visually and inspect components. It also has a complete list of checklist and inspection guidelines to ensure quality performance from your equipment.
MaintainX
04/26/2021

2019 CLARK S25D IC Pneumatic 50-250 Hours PM

The 2019 CLARK S25D IC Pneumatic 50-250 Hours preventive maintenance form helps you check your truck visually and inspect components. It also has a complete list of checklist and inspection guidelines to ensure quality performance from your equipment.

    Check truck visually and inspect components.

    Test drive truck/check functional performance.

    Overhead Guard

    Load Handling Components

    Inspect the:

    Carefully check the lift chains for

    Air clean truck and radiator

    Check torque on critical fasteners.

    Critical items include:

    Drain and replace engine oil.

    It is recommended to:

    Engine oil at operating temperature is hot and can cause burns. Beware of splashing oil.

    Replace engine oil filter.

    Changing the Engine Oil and Oil Filter

    Inspect / adjust fan belts.

    Inspect the

    Drain / flush radiator coolant.

    If the level is low, add a 50/50 mixture of specified coolant and water to the correct fill level. If you have to add coolant more than once a month or if you have to add more than one litre at a time, check the coolant system for leaks.

    Check engine ignition and timing.

    You will start the engine to complete the functional tests, so be sure that:

    Engine tune-up.

    Be sure that the travel area is clear in front of the truck.

    Check battery.

    Inspect the battery for

    Check transmission fluid level.

    Before checking

    Change drive axle fluid. (cooling system not equipped) - Cooling system equipped : 2,000 hours

    • Capture11.PNG

    Check brake condition and wear.

    Parking Brake

    • Capture12.PNG

    Check drive axle mounting and fasteners.

    Critical items include:

    Lubricate steer axle linkage.

    Lubrication and inspection of truck chassis components, including :

    Inspect the steering cylinder piston

    Check / lubricate steer axle wheel bearings

    Horn Button

    Change / replace hydraulic sump oil filter and breather

    Sump Tank Breather Maintenance and Inspection

    Change / replace hydraulic sump fluid and oil filter.

    Lubricate tilt cylinder rod ends.

    Upright and Tilt Cylinder Lubrication

    Lift Chains

    Check lift chain adjustment and wear.

    During the inspection, check for the following conditions:

    Check / lubricate lift chains.

    Lift Chain Wear and Replacement Criteria:

    • Capture9.PNG
Source: Clark

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.