General • Inspections

Daily Boiler Inspection - Additional Boiler

Inspect boiler and system components for proper function.

Ergon CMx

02/23/2023

Daily Boiler Inspection - Additional Boiler

Inspect boiler and system components for proper function.

Boiler

Boiler Name

Visual Linkage Inspection

Pass
Flag
Fail

Check Water Level (Sight Glass)

Pass
Flag
Fail

Steam Pressure of Boiler (PSI)

Regulated Gas Train Pressure (Inches of Water Column)

Stack Temperature (Fahrenheit)

Flame inspection

Pass
Flag
Fail

Clear Stack Emission

Emission at boiler stack should be clear. Otherwise immediately shutdown boiler and call CMx or Local Vendor

Pass
Flag
Fail

Test Low Water Cut off on Boiler

Pass
Flag
Fail

Perform Boiler Blow Down?

Yes
No
N / A

Operator On Duty

Comments

Files/Pictures

Add or drag pictures

Instructions

Continued safe operation of a boiler depends on regular maintenance and testing of the boiler and its operating and protective controls. The tests and checks outlined above are designed to determine whether or not the boiler and controls are in good operating condition

Low Water Cutoff Test - Slowly open bottom column drain while boiler is operating. Observe level in sight glass. Burner should shutoff before level in slight glass is out of view. Otherwise the test failed and call CMx or local vendor ASAP. If the boiler is equipped with 2 columns, then repeat procedure on 2nd column.

Should any check or test include that the device being tested or observed is not in good operating condition it should be repaired immediately. Record repairs or changes under the "Comments" so that a complete record will be available for review at any time.

Source: Ergon CMx (Community Member)