HYDRAULIC OIL FILTER
WARNING: At operating temperature the hydraulic oil is HOT. Do not permit the hot oil to touch the skin and cause a burn.
CAUTION :Do not permit dirt to enter the hydraulic system when the oil level is checked or the filter is changed.
Never operate the hydraulic pump without oil in the hydraulic system. The operation of the hydraulic pump without oil will damage the pump.
The air filter canister should not be opened until an air filter element replacement is required. An air filter element replacement is required when one of the following occurs:
Do not operate the lift truck until the air filter element has been replaced.
NOTE: Forks must be removed or installed by trained per- sonnel only.
Figure 47. Forks Check
WARNING: Small amounts of water in the brake system can cause reduced braking performance if the water reaches the wheel cylinder area. Do not allow water entry, ensure that the sealed reservoir lid is properly replaced. If the brake system has a power as
On lift trucks with wet brake drive axles, only use Dex- ron III oil from sealed container in the master cylinder. On lift trucks with dry brake drive axles, only use SAE J-1703 (DOT 3) brake fluid in the master cylinder.
Loss of fluid from the brake fluid reservoir indicates a leak. Repair the brake system before using the lift truck. Replace the brake fluid in the system if there is dirt or water in the system. Failure to observe the above warnings could result in death
Check Lining Thickness.
Dry Brakes S40-70FT, S55FTS (F187)
Dry Brakes H40-70FT (L177)