Back

Doosan D15S-5 Pneumatic Forklift 2000 Hours / 1 Year

The Doosan D15S-5 Pneumatic Forklift 2000 Hours / 1 Year is a preventive maintenance form done annually that keeps your forklift in prime working condition. Maximize your forklifts capabilities by consistently performing maintenance yearly.
MaintainX
04/26/2021

Doosan D15S-5 Pneumatic Forklift 2000 Hours / 1 Year

51 steps
The Doosan D15S-5 Pneumatic Forklift 2000 Hours / 1 Year is a preventive maintenance form done annually that keeps your forklift in prime working condition. Maximize your forklifts capabilities by consistently performing maintenance yearly.
  • You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures.

  • Steer Wheel Bearings – Reassemble

  • Park the lift truck level with the forks lowered, park- ing brake engaged, transmission in NEUTRAL and the engine stopped.

  • 2.PNG
  • 3.PNG
  • 4.PNG
  • NOTE : Deflate tire before removing wheel nuts from the truck.

  • 5.PNG
  • Drive Wheel Bearing - Reassemble

  • Consult your DOOSAN lift truck dealer for the proper wheel bearing reassembling procedure.

  • Reassembling of bearings and adjustment procedure must be made by a trained mechanic or deal- er personnel.

  • Cooling System – Clean, Change

  • WARNING: At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury.

  • Check the coolant level only after the engine has been stopped and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.

  • Coolant is included antifreeze for forbidding corrosion. Avoid contact with the skin and eyes to prevent personal injury. Use all cleaning solution with care.

  • The Lift truck must be level, the forks lowered, the parking brake engaged, the transmission in NEUTRAL and the engine stopped and cool.

  • 7.PNG
  • V2403 Diesel Engine

  • G420F(E) 2.0L LPG/Gasoline Engine

  • 10.PNG
  • NOTICE: Hold the drain port when the radiator drain valve is turned because the tank and the drain port are separated.

  • Fork - Inspect

  • Forks should be inspected, at a minimum, every 12 months. If the truck is being used in a multi-shift or heavy duty operation, they should be checked every six months.

  • 12.PNG
  • 13.PNG
  • 14.PNG
  • 15.PNG
  • 16.PNG
  • 17.PNG
Source: Doosan

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.