Back

Allied Z-Series (3 - 6 ZCA): Regular Maintenance

This procedure focuses on Condenser oils, E-Supply Blower Wheels, and Lubrication. The main purpose of regular maintenance is to ensure that all equipment required for production is operating at 100% efficiency at all times.
MaintainX
10/24/2021

Allied Z-Series (3 - 6 ZCA): Regular Maintenance

This procedure focuses on Condenser oils, E-Supply Blower Wheels, and Lubrication. The main purpose of regular maintenance is to ensure that all equipment required for production is operating at 100% efficiency at all times.

    A-Filters

    Units are equipped with temporary filters which must be replaced prior to building occupation. See table 13 for correct filter size. Refer to local codes or appropriate jurisdiction for approved filters..

    • Screenshot2021-02-17at10.15.16AM.png

    NOTE-Filters must be U.L.C. certified or equivalent for use in Canada.

    To change filters, open filter access panel on back side of unit. See figure 13. Lift filter stop to remove filters. See figure 14.

    B-Lubrication

    All motors are lubricated at the factory. No further lubrication is required.

    • Screenshot2021-02-17at10.16.12AM.png
    • Screenshot2021-02-17at10.16.31AM.png

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.