Back

Allied K-Series (2-7.5 KGA): Regular Maintenance

This procedure focuses on Condenser oils, E-Supply Blower Wheels, and Lubrication. The main purpose of regular maintenance is to ensure that all equipment required for production is operating at 100% efficiency at all times.
MaintainX
05/03/2021

Allied K-Series (2-7.5 KGA): Regular Maintenance

0 steps
This procedure focuses on Condenser oils, E-Supply Blower Wheels, and Lubrication. The main purpose of regular maintenance is to ensure that all equipment required for production is operating at 100% efficiency at all times.
  • E-Flue Passageway and Flue Box

  • Remove flue box cover only when necessary for equipment repair. Clean inside of flue box cover and heat exchanger tubes with a wire brush when flue box cover has to be removed. Install a new flue box cover gasket and replace cover. Make sure edges around flue box cover are tightly sealed.

  • G-Evaporator Coil

  • Inspect and clean coil at beginning of each cooling season. Clean using mild detergent or commercial coil cleanser. Flush coil and condensate drain with water taking care not to get insulation, filters and return air ducts wet.

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.