General • Maintenance

Agility™ Centrifugal Water-Cooled Chiller - Annual Maintenance

This annual procedure helps you inspect the condenser tubes for fouling and to have it cleaned if necessary. It will also let you inspect and clean the ifm efector flow detection sensors.

MaintainX

10/24/2021

Agility™ Centrifugal Water-Cooled Chiller - Annual Maintenance

This annual procedure helps you inspect the condenser tubes for fouling and to have it cleaned if necessary. It will also let you inspect and clean the ifm efector flow detection sensors.

Contact your local Trane Service Agency to shut down the chiller once each year and perform the following:

Manual Link

Perform all weekly and monthly maintenance procedures.
Leak check the chiller, inspect safety controls, and inspect electrical components, such as magnetic bearing controller and Uninterruptible Power Supply (UPS).
Inspect all piping components for leakage and/or damage. Clean out any in-line strainers.
Clean and repaint any areas that show signs of corrosion.
Inspect vent piping of all relief valves for presence of refrigerant to detect improperly sealed relief valves.
Inspect the condenser tubes for fouling. Clean if necessary; refer to “Cleaning the Condenser,” p. 63.
Visually inspect waterbox hinges to ensure that hinges have not been damaged or altered.

Note: If, after 10 years, the battery has not been replaced, Trane recommends replacing the battery.

Source: Trane (www.trane.com)

Contact your local Trane Service Agency to shut down the chiller once each year and perform the following:

Perform all weekly and monthly maintenance procedures.

Leak check the chiller, inspect safety controls, and inspect electrical components, such as magnetic bearing controller and Uninterruptible Power Supply (UPS).

Inspect all piping components for leakage and/or damage. Clean out any in-line strainers.

Clean and repaint any areas that show signs of corrosion.

Inspect vent piping of all relief valves for presence of refrigerant to detect improperly sealed relief valves.

Inspect the condenser tubes for fouling. Clean if necessary; refer to “Cleaning the Condenser,” p. 63.

Visually inspect waterbox hinges to ensure that hinges have not been damaged or altered.

Note: If, after 10 years, the battery has not been replaced, Trane recommends replacing the battery.