Back

OSM 1.99 FALL ARREST HARNESS MONTHLY INSPECTION ***IF ANY STEP IS FLAG/FAIL TAKE HARNESS OUT OF SERVICE*** [WS]

Use this procedure to make sure that your harness is clean of corrosion, pitting or heat/cold damage. Harness should be generally clean, any contamination cannot interfere with the harness's serviceability or function,
UNVR - 0077 - Willow Springs
04/23/2022

OSM 1.99 FALL ARREST HARNESS MONTHLY INSPECTION ***IF ANY STEP IS FLAG/FAIL TAKE HARNESS OUT OF SERVICE*** [WS]

6 steps
Use this procedure to make sure that your harness is clean of corrosion, pitting or heat/cold damage. Harness should be generally clean, any contamination cannot interfere with the harness's serviceability or function,
  • WEBBING: Grasp the webbing with your hands 6 to 8 inches apart. Bend the webbing in an inverted "U". Look for frayed edges, broken fibers, pulled stiches, cuts, burns and other damage. Follow this procedure for the entire length of the webbing, inspecting both sides of the strap.

    • Pass
    • Flag
    • Fail
  • STITCHING: Verify the fall indicator stitching has not been broken. Wear should be minimal. There should be no frayed or cut fibers.

    • Pass
    • Flag
    • Fail
  • TAGGING: Verify the tag is present and ANSI/OSHA compliance information is legible.

    • Pass
    • Flag
    • Fail
  • HARDWARE: Check D-rings for distortion, cracks, breaksand rough or sharp edges. The D-ring should pivot freely. D-ring back pads should be inspected for damage. Check plastic for any cracks or distortions. Inspect the buckle for distortion. The outer and center bars must be straight. Inspect for loose, distorted or broken grommets. Webbing should not have additional punched holes. Grommets should not rotate. Buckle tongue should not be bent or distorted. Tongue should move freely. Check for sharp edges.

    • Pass
    • Flag
    • Fail
  • STORAGE AND CLEANING: Harness should be clean of corrosion, pitting or heat/cold damage. Harness should be generally clean, any contamination cannot interfere with the harness's serviceability or function,

    • Pass
    • Flag
    • Fail
  • Technician Signature.

    Click here to sign
Source: UNVR - 0077 - Willow Springs (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Global Procedure Library is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.