Back

AERO® Semi-Custom Central Station Air Handler 39M: Inspection

The procedures here focus on the general maintenance of your equipment, inspection and fan shaft bearing removal.
MaintainX
09/08/2022

AERO® Semi-Custom Central Station Air Handler 39M: Inspection

The procedures here focus on the general maintenance of your equipment, inspection and fan shaft bearing removal.

    Gas-Fired Furnaces (Duct and Rack System)

    Follow these procedures for inspection and operation check.

    INSPECTION

    The duct furnace or furnace module should be inspected annually by a qualified service agency. The condition of the burners, heat exchanger, draft inducer, vent system, operating controls and wiring should be determined. Check for obvious signs of deterioration, accumulation of dirt and debris, and heat or water related damage. Any damaged or deteriorated parts should be replaced before the unit is put back into service.

    • Pass
    • Flag
    • Fail

    Label all wires prior to disconnection when servicing unit, Wiring errors can cause improper or dangerous operation. Verify proper operation after servicing.

    • Pass
    • Flag
    • Fail

    Inspect burners, heat exchanger, induced draft fan and vent ducts and clean as necessary.

    • Pass
    • Flag
    • Fail

    Check the heat exchanger for cracks. If any are present, replace heat exchanger before putting unit back into service.

    • Pass
    • Flag
    • Fail

    Check the attachment points of the duct furnace to the cabinet to verify that they are air-tight. For a rack system module, check the attachment points to the cabinet or ducts to verify that they are air-tight.

    • Pass
    • Flag
    • Fail

    Check the automatic gas valve to ensure that the gas valve seat is not leaking.

    • Pass
    • Flag
    • Fail

    Check wiring connections to be sure they are secure, and inspect wiring for any deterioration.

    • Pass
    • Flag
    • Fail

    ! CAUTION

    If any of the original wiring needs to be replaced, it must be replaced with wiring materials suitable for 221°F (105°C). Unsuitable wiring materials may cause equipment damage.

    OPERATION CHECK

Source: MaintainX (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.